The Proper Way of Pressure Washing Decks

A pressure washer can be leased these days and if you are an avid fan of DIY, then you might have tried cleaning your driveway on your own. Pressure washing shouldn’t take much more than gripping the nozzle after hooking it up to your water supply, right? Wrong.  

Pressure washing may be a little harder than it seems. If you decide to use a pressure washer, there will be some safety issues to consider. You also want to make sure that you do not damage your deck. When you use a pressure washer to clean decks, you’re likely to remove about a quarter of the wood surface. This damage is incredibly difficult and expensive to fix.   

Even so, the daily cleaning of your deck is probably the most important part of its maintenance. Maintaining the deck can add several years of life to it. Also, it will save you loads of time and money in the future.  

How to Clean Decks   

To clean decks, use the pressure washer spray over the walls, following a sweeping motion. Your arm will rotate while you’re sleeping, and you must resist that. You should always maintain a level and reasonable distance from the deck’s floor.  

Stand a few steps back and spray the wood grain with just the right amount of pressure to minimize the harm done to the grains of wood. Overlap the places that you’ve just washed with the areas that you’re going to clean up.  Another good technique to follow is called feathering. This will help prevent any visible marks left by pressure washing. This technique is also referred to as edges cleaning.   

Once the work is finished, allow the deck to dry for about 24 hours before checking on your work. Decks can look very different when they’re wet. You want to make sure it looks all right before you call the job done. Inspect the job that you did thoroughly. Make sure you left no edge behind, and that you have cleaned every part of the floor.  

How to Care for the Wood Fibers  

There is no way around it. The wood fibers become susceptible to damage when it gets wet. Hopefully, you’ve done minimal damage to it, and you won’t notice too much of a fiber issue. But even a small amount of elevated fibers can cause serious splinter problems.  

You’ll want to sand your deck after the cleaning to keep it friendly to the feet and hands. You may just need to do spot sanding. Check the entire deck, especially the part with the highest exposure to water. On the other hand, sanding the whole deck may be the best and safest choice. Use an orbital sander with a 5-inch sheet to get the best results. Then use 60-to 80-grit sandpaper for the deck’s surface. Use nothing higher than 100-grit sandpaper for the handrails.   

As you can see, pressure washes your deck may be harder than it seems. But, with the right knowledge, tools, and techniques, there’s no reason you shouldn’t be able to do a good job. If ever you need help, the experts in pressure washing San Antonio are there to support you.